Changes

Jump to navigation Jump to search
3,748 bytes added ,  03:04, 22 October 2020
no edit summary
[[File:TH-D74A.jpg|none|thumb|Fully Assembled Kenwood TH-D74A|alt=]]Full teardown pictures and videos of the TH-D74 along with notes on reverse engineering and obtaining a copy of the firmware. 
==Teardown Video==
20 6 minute video @ 3x playback speed showing full disassembly of the radiowith commentary, full length video with no audio[https://youtu.be/Q_n_bs6f8gE here].
<youtube width="320" height="240">UVwoPPe6DwQQ_n_bs6f8gE</youtube>
==Teardown PCB Pictures==
<gallery mode="packed-hover" widths="300" heights="200">
File:TH-D74A Processor board Top.jpg|Processor Board Top
File:TH-D74A Processor.jpg|Processor Shield Removed
File:TH-D74A GPS Circuit.JPG|GPS circuit normally under a shield.
File:TH-D74A Processor board bottom.jpg|Processor Board Bottom
File:TH-D74A Transceiver board top.jpg|Transceiver Board Top
File:TH-D74A FJ-X5 top.jpg|FM Radio Module Top
File:TH-D74A FJ-X5 bottom.jpg|FM Radio Module Bottom
</gallery>[[File:TH-D74A Processor board Top.jpg|none|thumb|TH-D74A Processor board Top]][[File:TH-D74A Processor.jpg|none|thumb|TH-D74A Processor (shield removed)]]==Port and Test Point Identification==[[File:TH-D74A Processor board bottom.jpg|none|thumb|TH-D74A Processor board bottom]][[File:TH-D74A Transceiver board top.jpg|none|thumb|TH-D74A Transceiver board top]][[File:TH-D74A Transceiver board top zoom 1.jpg|none|thumb|TH-D74A Transceiver board top zoom 1]]<gallery mode="packed" heights="200">[[File:Kenwood TH-D74A Transceiver board top zoom 2D74 Control Board Boot Pins.jpgjpeg|none|thumb|TH-D74A Transceiver board top zoom 2]][Test point locations for Boot[File:TH-D74A Transceiver board bottom.jpg|none|thumb|TH-D74A Transceiver board bottom]][[File:THpins which set the boot-D74A Transceiver board bottom zoom 1up mode of the OMAP L138 processor, in this case to boot from NOR Flash.jpg|none|thumb|TH-D74A Transceiver board bottom zoom 1]][[File:TH-D74A Transceiver board bottom zoom 2OMAP L138 Boot Mode Selection.jpgjpeg|none|thumb|TH-D74A Transceiver board bottom zoom 2]][[File:OMAP L138 Boot Mode Selection, TH-D74A FJ-X5 D74 is set to boot into NOR Flash at the topof the list.jpg|none|thumb|TH-D74A FJ-X5 top]][[File:TH-D74A FJ-X5 bottomJTAG Pinout.jpgpng|none|thumb|TH-D74A FJ-X5 bottom]]JTAG pinout</gallery><br /> 
==Modules and Interconnects==
[[<gallery mode="packed" heights="200">File:TH-D74A LCD front.jpg|none|thumb|TH-D74A LCD front]]Front[[File:TH-D74A LCD back.jpg|none|thumb|TH-D74A LCD back]]Back[[File:TH-D74A FM Antenna.jpg|none|thumb|TH-D74A FM Antenna]]Front[[File:TH-D74A FM Antenna 2.jpg|none|thumb|TH-D74A FM Antenna 2]]Rear[[File:TH-D74A Interconnect.jpg|none|thumb|TH-D74A Interconnect]]Top[[File:TH-D74A Interconnect 2.jpg|none|thumb|TH-D74A Interconnect 2]]Bottom[[File:TH-D74A Selector.jpg|none|thumb|TH-D74A Channel Selector]]</gallery><br />
==Mechanical Pictures==
[[<gallery mode="packed" heights="200">File:TH-D74A Front case interior.jpg|none|thumb|TH-D74A Front case interior]]Case Interior[[File:TH-D74A Metal Frame front.jpg|none|thumb|TH-D74A Metal Frame front]]Front[[File:TH-D74A Metal frame back.jpg|none|thumb|TH-D74A Metal frame back]]Frame Back[[File:TH-D74A Metal frame side 1.jpg|none|thumb|TH-D74A Metal frame side 1]]Frame Connector Side[[File:TH-D74A Metal frame side 2.jpg|none|thumb|TH-D74A Metal frame side 2]]Frame Button Side[[File:TH-D74A Metal frame top.jpg|none|thumb|TH-D74A Metal frame top]]Frame Top[[File:TH-D74A Rubber.jpg|none|thumb|Rubber GasketsFile:TH-D74A Rubber]]Screws.jpg|Screws and Knobs</gallery>==Reverse Engineering Efforts==[[File:Kenwood TH-D74A ScrewsD74 and JTAGulator.jpg|none|thumb|Kenwood TH-D74A ScrewsD74 connected to JTAGulator]] ===High level goals=== *Obtain a copy of the firmware for analysis/modification*Understand how the radio works and what test ports are available internally ====Obtaining firmware==== *Determine routes of attack**JTAG Port**Serial Port**Hardware attack - Remove Flash Memory and read directly (possibly encrypted/obfuscated)**USB data capture - Packet capture firmware update (possibly encrypted/obfuscated) Initially the radio was opened and wires were soldered to some test points and an interesting PCB footprint that I suspected was JTAG as seen in the video below. <youtube width="320" height="240">EZP2DVU9IvQ<br /youtube=====Serial Port=====The serial port turned out to just be control data sent from the CPU board to the transceiver board, explained further below. Removing the flash memory is an option although it is a BGA package so not sure about soldering wires to it so it can be read out. Furthermore, the OMAP-L138 processor seems to have a few protection mechanisms. Encryption of the firmware is one of them so that route might be useless.  ====Hardware Attack====
*Desolder flash memory chip
*Re-Ball BGA and clean in preparation for socket
*Insert into BGA socket and read contents using [https://www.embeddedcomputers.net/products/FlashcatUSB_XPORT/ FlashCATUSB XPORT] with [https://www.embeddedcomputers.net/products/ParallelAdapters/ BGA-64 (LAE064)] socket
 
Other than the obvious challenge of desoldering and reballing a BGA, this worked great to get a complete image of the firmware! The firmware on the flash is not encrypted or obfuscated in any way so it's possible to make use of it immediately.
 
Cost breakdown to get complete firmware image using this method: '''$330 USD'''
 
*$145 - Replacement Processor board for TH-D74 (eBay)
*$40 - [https://www.embeddedcomputers.net/products/FlashcatUSB_XPORT/ FlashcatUSB XPORT]
*$145 - [https://www.embeddedcomputers.net/products/ParallelAdapters/ BGA-64 (LAE064)] Socket
 
Having a copy of the firmware for modification and analysis... PRICELESS!
 
====USB Data Capture====
This method costs a lot less than the hardware attack, like $330 less! See the YouTube video below for a walk-through. The software tools used are listed below, I am sure other tools would work but this is what I used.
 
'''''Have a better method? Create an account and update the wiki!'''''
 
<youtube width="320" height="240">BwFnZOvw0wk</youtube>
 
[https://www.hhdsoftware.com/hex-editor Hex Editor Neo] - Allows bitwise operations and other cool features with a 14 day free trial!
 
[https://www.eltima.com/products/usb-port-monitor/ USB Analyzer] - By Eltima Software, it captures USB traffic and lets you easily export the binary data. It also comes with a 14 day free trial!
 
[https://github.com/BitBangingBytes/Firmware-Parse-Tool Firmware Parse Tool] - Python program to strip header bytes from USB data captures
 
====Understand how the radio works====
There is a serial port labeled SCTX and SCRX (See Processor Board Bottom picture above), both of these lines appear to be transmit only from the top CPU board down to the bottom transceiver board. As the radio is tuned from one frequency to another the SCRX line has a lot of activity, when the transmitter is keyed up the SCTX line has activity. Below is a sample of what is seen on the SCRX line. [[Travis Goodspeed]] commented to me on Twitter that these commands seemed similar to the Rig Control commands sent from PC's to radio's to control them.
{| class="wikitable mw-collapsible mw-collapsed"
!SCRX
|-
|J0000
|-
|K0000
|-
|G0283
|-
|`0
|-
|G1283
|-
|B06EE14
|-
|B0A03CE
|-
|B0C0028
|-
|B11E960
|-
|B180000
|-
|B140000
|-
|B1C2812
|-
|B200018
|-
|B280A68
|-
|G;7:3
|-
|K1900
|-
|a7:6
|-
|B1C2C12
|-
|B140000
|-
|B1C2812
|-
|B200018
|-
|B280A68
|-
|F41
|-
|J01
|-
|G;7:3
|-
|`0
|}
==Datasheets==
[[:Filehttps://wiki.recessim.com/w/images/5/5d/Kenwood_TH-D74A_Datasheet_-_IC-701_-_DRAM.pdf Kenwood TH-D74A Datasheet - IC-701 - DRAM] [https://wiki.recessim.com/w/images/c/c6/Kenwood_TH-D74A_Datasheet_-_IC-702_-_omap-l138.pdf|Kenwood TH-D74A Datasheet - IC-701 702 - omap- DRAMl138[https://wiki.recessim.com/w/images/2/25/Kenwood_TH-D74A_Datasheet_-_IC-705_-_FLASH_MEMORY.pdf Kenwood TH-D74A Datasheet - IC-705 - FLASH MEMORY]
[[https:File:Kenwood TH-D74A Datasheet - IC-702 - omap-l138//wiki.recessim.com/w/images/f/f7/OMAP_L138_BootLoader.pdf|Kenwood TH-D74A Datasheet - IC-702 - omapUsing the OMAP-l138]L138 Bootloader]
[[https:File:Kenwood TH-D74A Datasheet //wiki.recessim.com/w/images/c/cd/IC- IC707_-705 _Not_exact_match_but_same_family_- FLASH MEMORY_WM8940_v4.3.pdf|Kenwood THIC-D74A Datasheet - IC707 -705 Not exact match but same family - FLASH MEMORY]WM8940]
[[:File:IC-707 - Not exact match but same family - WM8940 v4.3.pdf|IC-707 - Not exact match but same family - WM8940]]<br /><references />

Navigation menu