Changes

Jump to navigation Jump to search
821 bytes added ,  03:59, 8 June 2020
<youtube width="320" height="240">EZP2DVU9IvQ</youtube>
The serial port turned out to just be control data sent from the CPU board to the transceiver board, explained further below. Removing the flash memory is an option although it is a BGA package so not sure about soldering wires to it so it can be read out. Furthermore, the OMAP-L138 processor seems to have a few protection mechanisms. Encryption of the firmware is one of them so that route might be useless.  If a donor radio is stripped down to bare PCB then perhaps the boot-up config register values can be tweaked or other hard coded settings (usually using resistors) to alter the boot procedure and allow further debugging. ====Understand how the radio works====There is also a serial port labeled SCTX and SCRX(See Processor Board Bottom picture above), both of these lines appear to be transmit only from the top CPU board down to the bottom transceiver board. As the radio is tuned from one frequency to another the SCRX line has a lot of activity, when the transmitter is keyed up the SCTX line has activity. Here Below is a sample of what is seen on the SCRX line. [[Travis Goodspeed]] commented to me on Twitter that these commands seemed similar to the Rig Control commands sent from PC's to radio's to control them.
{| class="wikitable mw-collapsible mw-collapsed"
!SCRX
|`0
|}
 
====Understand how the radio works====
<br />
==Datasheets==
[[:File:Kenwood TH-D74A Datasheet - IC-701 - DRAM.pdf|Kenwood TH-D74A Datasheet - IC-701 - DRAM]]

Navigation menu