Landis+Gyr Residential Meter: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
Generation 4 and older boards based on M16C processor<gallery mode="packed" heights="200"> | === Generation 4 and older boards based on M16C processor === | ||
<gallery mode="packed" heights="200"> | |||
File:LandisGyr PCB Blank1.JPG|Blank PCB Components side | File:LandisGyr PCB Blank1.JPG|Blank PCB Components side | ||
File:LandisGyr PCB Blank2.JPG|Blank PCB Screen and Buttons side | File:LandisGyr PCB Blank2.JPG|Blank PCB Screen and Buttons side | ||
| Line 9: | Line 10: | ||
File:LandisGyr PWB-72127 RevA Top.JPG|Dual board meter, older design, metering board bottom | File:LandisGyr PWB-72127 RevA Top.JPG|Dual board meter, older design, metering board bottom | ||
</gallery> | </gallery> | ||
----<gallery mode="packed" heights="200"> | ---- | ||
=== Generation 5 smart meter based on ARM Cortex-M processor === | |||
<gallery mode="packed" heights="200"> | |||
File:LandisGyr PCB 24-2411 RevAC TopScreen.JPG|Top of Gen5 meter board with LCD screen | File:LandisGyr PCB 24-2411 RevAC TopScreen.JPG|Top of Gen5 meter board with LCD screen | ||
File:LandisGyr PCB 24-2411 RevAC TopNoScreen.JPG|Top of Gen5 meter board with the LCD screen removed | File:LandisGyr PCB 24-2411 RevAC TopNoScreen.JPG|Top of Gen5 meter board with the LCD screen removed | ||
Revision as of 00:23, 18 April 2022
Generation 4 and older boards based on M16C processor
-
Blank PCB Components side -
Blank PCB Screen and Buttons side -
PCB with EM250 Zigbee chip and lower accuracy Teridian chip -
PCB with EM357 Zigbee chip and higher accuracy Teridian chip -
Dual board meter, older design, brain/network board top -
Dual board meter, older design, brain/network board bottom -
Dual board meter, older design, metering board top -
Dual board meter, older design, metering board bottom
Generation 5 smart meter based on ARM Cortex-M processor
-
Top of Gen5 meter board with LCD screen -
Top of Gen5 meter board with the LCD screen removed -
Bottom of Gen5 meter board, ATSAM4C32 processor is under the large brown capacitor seen in the bottom middle of the PCB. -
Red circled spots are missing 0 ohm resistors you need to solder bridge to enable JTAG connector to function.
