Open main menu

Changes

176 bytes added ,  03:13, 30 September 2020
add ADC config
#Place the plastic strap around the radiosonde as originally equipped. You can likely push the staples back into the styrofoam if they're left intact.
#Optionally, re-attach the paper wrapper to the payload, or feel free to attach your own wrapper or identification.
#Replace the plastic pins that hold the plastic strap to the radiosonde payload.
#Ensure all sensors and antenna are extended and oriented properly. Be sure to bend the antenna into a dipole orientation similar to how it shipped (about 5.75" of the shorter lead folded back and held about 0.5" away from the twin-lead coming from the radiosonde)
#Optionally, use a loop of tape to ensure the dipole antenna remains positioned appropriately, similar to how the antenna was originally rigged.
MCCBCR does not appear to be initialized, meaning beeper-mode is disabled.
 
<br />
 
=== ADC Configuration ===
ADCDRL does not appear to be used, thus the ADC is operated as an 8-bit ADC instead of 10-bit.
 
ST7 ADC AIN8 appears to be the only one used.
==Modifications==