Page history
4 October 2020
→GPS Initialization: Document GPS initialization packets
m+121
Document firmware GPS initialization
+297
Add link to TSIP docs
m+84
Add CC1050 errata link
m-130
3 October 2020
CC1050 section
-81
no edit summary
m+40
Fix ST7:PC0 which is connected to CC1050:PALE
-8
Document analog mux more
+155
J5 pinout
+100
a couple extra GPS pinout notes
+53
SP1 cleanup & details
-10
Card-edge connector
+190
Add link to ST7 programming manual
m+161
2 October 2020
add gps pinout notes
+1,153
add balloon launched for SEO
m+17
→Instruction Timing Tables: Add register->register LD instruction
m+65
Add some instruction timings from simulator
+631
30 September 2020
Reformatted Card Edge Connector
m+187
document the bit-synth interrupt
+153
→Disassembly
+8
→Photos
+195
add ADC config
+176
Let's not use duct tape for closing it up.
+237
29 September 2020
→Option Bytes: Replaced the OptionByte.png screenshot with a table. Hopefully this will allow for better accessibility.
+507
→Option Bytes: Changed option bytes header format
-4
→GPIO Initialization: Document PF6
+199
→Original Firmware: Document MCC initialization
+459
→Original Firmware: Document initial GPIO states
+1,053
→Original Firmware: Added option byte info
+133
Note tool used for ROMDUMP
m+8
Add note about firmware
+276
28 September 2020
→Disassembly: image upload
m+194
small adjustments
m+425
Disassebly, Reassembly and powering the sonde
+4,409
Document this board uses TSIP binary GPS protocol
+79
Document default is TSIP for GPS
+78
Fix ST7 frequencies
+3
27 September 2020
Document U17. I can't figure out how to inline post an image, I uploaded it but it won't insert.
+64
add sections for CC1050<->ST7 and GPS<->ST7 busses
+722
document some more pins
+22
Added references; fixed a typo
+518
Document dip switch pins
+152
Add notes on ST7 pins
+332
add gps pinout notes
+273
Clarified Card-edge pins 23, 26
+1
Add instruction cycle timing notes
+353
add possible CPU speeds
+141
Add notes about 16MHz crystal and clock buffer
+72
17 September 2020
→Relative Humidity Circuit: (m) Converted schematic sketch to SVG drawing
-50
→RF Transmitter Circuit: Changed TX schematic from png to svg for readability
m+46