Page history
28 October 2020
→ST7 Programming: Started theory of operation section
+292
→ST7 Programming: Added info on the Programmer PCB and Card Edge interface PCB
+7,445
24 October 2020
19 October 2020
16 October 2020
11 October 2020
8 October 2020
6 October 2020
5 October 2020
4 October 2020
→Interrupts: Document ei3_int
m+70
→GPS Subsystem: Document how PPS works
m+18
→Connectors: Updated Card edge connection Pin 30
+30
→GPS Initialization: Document GPS initialization packets
m+121
Document firmware GPS initialization
+297
Add link to TSIP docs
m+84
Add CC1050 errata link
m-130
3 October 2020
CC1050 section
-81
no edit summary
m+40
Fix ST7:PC0 which is connected to CC1050:PALE
-8
Document analog mux more
+155
J5 pinout
+100
a couple extra GPS pinout notes
+53
SP1 cleanup & details
-10
Card-edge connector
+190
Add link to ST7 programming manual
m+161
2 October 2020
add gps pinout notes
+1,153
add balloon launched for SEO
m+17
→Instruction Timing Tables: Add register->register LD instruction
m+65
Add some instruction timings from simulator
+631
30 September 2020
Reformatted Card Edge Connector
m+187
document the bit-synth interrupt
+153
→Disassembly
+8
→Photos
+195
add ADC config
+176
Let's not use duct tape for closing it up.
+237
29 September 2020
→Option Bytes: Replaced the OptionByte.png screenshot with a table. Hopefully this will allow for better accessibility.
+507
→Option Bytes: Changed option bytes header format
-4
→GPIO Initialization: Document PF6
+199
→Original Firmware: Document MCC initialization
+459
→Original Firmware: Document initial GPIO states
+1,053
→Original Firmware: Added option byte info
+133
Note tool used for ROMDUMP
m+8
Add note about firmware
+276
28 September 2020
→Disassembly: image upload
m+194
small adjustments
m+425
Disassebly, Reassembly and powering the sonde
+4,409
Document this board uses TSIP binary GPS protocol
+79
Document default is TSIP for GPS
+78
Fix ST7 frequencies
+3