Difference between revisions of "Landis+Gyr Residential Meter"

From RECESSIM, A Reverse Engineering Community
Jump to navigation Jump to search
(Created blank page)
 
(Added FCCID)
 
(8 intermediate revisions by the same user not shown)
Line 1: Line 1:
 +
===Early Generation Dual Board based on M16C processor===
 +
<gallery mode="packed" heights="200">
 +
File:LandisGyr PCBD-00106 Rev06 Top.JPG|Dual board meter, older design, brain/network board top
 +
File:LandisGyr PCBD-00106 Rev06 Bot.JPG|Dual board meter, older design, brain/network board bottom
 +
File:LandisGyr PWB-72127 RevA Bot.JPG|Dual board meter, older design, metering board top
 +
File:LandisGyr PWB-72127 RevA Top.JPG|Dual board meter, older design, metering board bottom
 +
</gallery>
 +
----
  
 +
===Generation 4 based on M16C processor===
 +
<gallery mode="packed" heights="200">
 +
File:LandisGyr PCB Blank1.JPG|Blank PCB Components side
 +
File:LandisGyr PCB Blank2.JPG|Blank PCB Screen and Buttons side
 +
File:LandisGyr PCB 24-1082 RevAE Sand1.jpg|Component side ground plane and traces sanded off
 +
File:LandisGyr PCB 24-1082 RevAE Sand2.jpg|Component side ground plane and screen side sanded off
 +
File:LandisGyr PCB 24-1082 RevAE Sand3.jpg|Screen side ground plane
 +
File:LandisGyr PCB 24-1082 RevAE Sand4.jpg|Screen side ground plane sanded off showing internal layer traces
 +
File:LandisGyr PCB 24-1082 RevAE.JPG|PCB with EM250 Zigbee chip and lower accuracy Teridian chip
 +
File:LandisGyr PCB 24-1562 RevAA.JPG|PCB with EM357 Zigbee chip and higher accuracy Teridian chip
 +
</gallery>
 +
----
 +
 +
===Generation 5 smart meter based on ARM Cortex-M processor (FCCID R7PEG1R1S6)===
 +
<gallery mode="packed" heights="200">
 +
File:LandisGyr PCB 24-2411 RevAC TopScreen.JPG|Top of Gen5 meter board with LCD screen
 +
File:LandisGyr PCB 24-2411 RevAC TopNoScreen.JPG|Top of Gen5 meter board with the LCD screen removed
 +
File:LandisGyr PCB 24-2411 RevAC Bottom.JPG|Bottom of Gen5 meter board, ATSAM4C32 processor is under the large brown capacitor seen in the bottom middle of the PCB.
 +
File:LandisGyr PCB 24-2411 RevAC JTAGSolderPoints.jpeg|Red circled spots are missing 0 ohm resistors you need to solder bridge to enable JTAG connector to function.
 +
</gallery>

Latest revision as of 17:12, 12 February 2023

Early Generation Dual Board based on M16C processor


Generation 4 based on M16C processor


Generation 5 smart meter based on ARM Cortex-M processor (FCCID R7PEG1R1S6)