346
edits
Changes
Jump to navigation
Jump to search
Toyota Paseo GT 1.5 odometer Starlet P9 mod (view source)
Revision as of 13:49, 31 December 2025
, 13:49, 31 December 2025no edit summary
This mod has the focus on not messing with the car wiring by depinning and changing the OEM wiring, but by modifying the GT cluster. After all while GT parts are relatively abundant, GT cars themselves are far less common on the road, making these odometers extremely cheap and readily available in the Japanese used-parts market.
There are three connectors on thee the back of these odometer clusters the connectors are both the same type however the pinout is different.
Most left connector is named '''A''', the middle one '''C''' and the most right one '''B'''. So: '''A, C, B.'''
| 3 || CUT
|-
| 4 || CUT (cut close at FU terminal, leave room to solder)
|-
| 5 || CUT
! Pin !! Rewire
|-
| 1 || CUT Must now connect to what '''PIN 5''' went to (FU terminal of fuel gauge)
|-
| 2 || CUT Must now connect to what '''PIN 1''' went to (high beam indicator light)
|-
| 3 || CUT Must now connect to the top of the high beam indicator light were we disconnected two traces.
|-
| 4 || CUT Must now connect to what '''PIN 3''' went to (left indicator light)
|-
| 5 || CUT Must now connect to what '''PIN 7''' went to (E/FE screw terminals)
|-
| 6 || CUT NC / OPEN
|-
| 7 || CUT NC / OPEN
|-
| 8 || CUT Must now connect to what '''PIN 6''' went to (reed switch, purpose unknown)
|-
| 10 || CUT Must now connect to what '''PIN 8''' went to (right indicator light)
|}
Important disconnect both high beam indicator light traces on the top. Just jump the rest of the trace.
Right Connector B (16-pin)
! Pin !! Rewire
|-
| 2 || CUT Must now connect to what '''PIN 3''' went to (now goes to ABS warning indicator light)|-| 3 || Must now connect to what '''PIN 4''' went to (now goes to check engine light)|-| 4 || NC / OPEN|-| 5 || Must now connect to what '''PIN 8''' went to
|-
| 3 7 || CUT NC / OPEN
|-
| 4 8 || CUT NC / OPEN
|-
| 5 9 || CUT NC / OPEN
|-
| 7 12 || CUT Must now connect to '''PIN 4''' on '''connector C (10pin)''' going to FU fuel gauge terminal
|-
| 8 14 || CUTMust now connect to what '''PIN 7''' went to
|-
| 9 15 || CUTMust now connect to what '''PIN 9''' went to
|}
